Page 1 of 1
Can't configure controls
Posted: Tue Sep 21, 2010 9:12 pm
by sagipson
Hey,
Â
When I try to configure the controls, every field says "Joy 1." I am not able to change any of these fields.
Â
If I close the program, plug in a controller, and try again, everything says "Joy 2" and does the same thing.
Â
If I select "Multiple Key Assignments" and click on one of the fields, "Joy 1" or "Joy 2" will repeat several times.
Â
Why can't I change any of the controls? Thanks so much.
Â
INFO:
SVN 926
This also happens in VBA
Running Win-7 64-bit
Can't configure controls
Posted: Wed Sep 22, 2010 10:28 am
by SCHUMI4EVER
Looks like something on your controller is stuck or alternatively on your joystick or whatever, I've had that sometime happen with me as well. Try and calibrate whatever it is you're trying to use, I know you may have done so in the past but try again. My steering wheel tends to like going sideways every time I boot my computer up with it till I open the calibration menu and just move it from left to right once then it's happy, same thing sometimes happens with my controller's one analog stick.
Can't configure controls
Posted: Wed Sep 22, 2010 8:04 pm
by Squall Leonhart
That or your controls drivers are just complete garbage.